Blind Motor (no radio), 7 lb lift
12 volt DC, 7 lb lift (3.5 Kg) using 1.5" O.D. tube, no radio. Often used for RV blind and shade REPLACEMENT or RETROFIT. Use with dash switches; see article with helpful tips from folks that have done it.
Categories
- Gift Certificates
- Custom Roller Shades and Blinds
- RV, MOTORHOME, TRAILER, & BOAT BLIND MOTORS
- DIY ROLLER BLIND Kits+ Single Units
- DIY WINDOW OPENER Kits+ Single Units
- DIY SKYLIGHT OPENER Kits+ Single Units
- SKYLIGHT SHADES & BOTTOM-UP BLINDS
- REMOTE CONTROLS
- COMMERCIAL VENTILATION Louvers
- Z-WAVE
- Home Automation
- Solar Systems
-
Accessories
- Power Supplies
-
LED Light Systems
- ♦ LED 12v Flexible Strip Lighting - Warm White
- ♦ LED 12v DC Bulb Replacement Lights - Warm White
- ♦ LED 12v Recessed Ceiling Pot Lights - Warm White
- ♦ LED 12v Swivel Flood Lights - Warm White
- ♦ LED 12v Dimmers, Switches, Controllers
- ♦ LED 12v Marine and RV Lighting Systems
- ♦ LED AC Bulb Replacement Lights - Warm White
- ♦ LED Flashlights
- Irrigation Equipment
Here is our article with helpful tips from folks that have done it
Specifications:
7 lb lift (3.5 Kg) when using 1.5" O.D. tube
- includes motor, tube adapters (1 3/8" - 35mm ID) and hanging brackets
- often used as RV shade and blind replacement motor
- control type: no radio, can use our DCC-1W-12-24 controller, or rocker switch
- lift capacity with standard adapters: 7 lb lift (3.5 Kg) with 1.5" O.D. tube
- torque: 6 Nm
- speed: 28 rpm
- nominal voltage: 12 v DC (safe for children and adults)
- minimum voltage: 9.5 v DC
- max turns in one direction: unlimited
- upper/lower limits: 'learning type', set by controller positioning
- current consumption: 700 mA (1500 mA at stall)
- noise level: 39db
- net weight: 272 g
- accepts industry standard 1.5" Rollease® OD tubing: YES (1/16" wall, 1 3/8" ID)
- accepts any round tubing: YES
- minimum tube length: 12" (30.5 cm)
- maximum tube length: unlimited
- tested life: 30,000+ cycles
