Author Topic: Routing wires when soldering wires to 2-ch wireless wall switch  (Read 9145 times)

lacoleman

  • Newbie
  • *
  • Posts: 5
    • View Profile
Routing wires when soldering wires to 2-ch wireless wall switch
« on: December 12, 2016, 05:36:41 PM »
I am wiring a 2-ch DCC-2W-RF wall switch using the wiring bundle from a DCC-ZWAVE-12R motor controller, connecting the wires to the pushbutton switches on the CB.  My question is whether there is a normal, preferred routing for the wires through the back of the wall switch unit.  I can see three possible routes but would rather follow the lead of someone who is has done this or is otherwise familiar with the usual practice.  Thanks.

admin

  • Administrator
  • Hero Member
  • *****
  • Posts: 92
    • View Profile
    • RollerTrol Automation Systems
Re: Routing wires when soldering wires to 2-ch wireless wall switch
« Reply #1 on: December 12, 2016, 10:09:31 PM »
Hi @lacoleman, there is no preferred route, it's just a matter of routing so you can still close the housing properly and not interfere with the operation.

Regards, Adrian

lacoleman

  • Newbie
  • *
  • Posts: 5
    • View Profile
Re: Routing wires when soldering wires to 2-ch wireless wall switch
« Reply #2 on: December 13, 2016, 04:46:42 AM »
OK, then I've got it.  Thanks.