Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - tcghost

Pages: [1]
Hi Adrian,

I just purchased the motor with the USB RFX controller to be used with Vera Lite so I figured I didn't need the remote control.

Hi, I recently purchased a rollertrol motor and am in the process of setting it up.

I was able to pair it fine using the USB RF controller and RFXmngr program, but am having trouble setting the limits of the motor.

RFXmngr has a "Set Limit" command which seems to work fine. However, it doesn't seem to have "Up" and "Down" commands that would work past the currently set limits.

I tried "Open" and "Close" commands but they don't go past the current limits.

Any help?

Pages: [1]