1
Tubular Motors: General Discussion / Routing wires when soldering wires to 2-ch wireless wall switch
« on: December 12, 2016, 05:36:41 PM »
I am wiring a 2-ch DCC-2W-RF wall switch using the wiring bundle from a DCC-ZWAVE-12R motor controller, connecting the wires to the pushbutton switches on the CB. My question is whether there is a normal, preferred routing for the wires through the back of the wall switch unit. I can see three possible routes but would rather follow the lead of someone who is has done this or is otherwise familiar with the usual practice. Thanks.