Shade & Blind Motors: RollerTrol Community Forum

General Category => Tubular Motors: General Discussion => Topic started by: lacoleman on December 12, 2016, 05:36:41 PM

Title: Routing wires when soldering wires to 2-ch wireless wall switch
Post by: lacoleman on December 12, 2016, 05:36:41 PM

I am wiring a 2-ch DCC-2W-RF wall switch using the wiring bundle from a DCC-ZWAVE-12R motor controller, connecting the wires to the pushbutton switches on the CB.  My question is whether there is a normal, preferred routing for the wires through the back of the wall switch unit.  I can see three possible routes but would rather follow the lead of someone who is has done this or is otherwise familiar with the usual practice.  Thanks.

Title: Re: Routing wires when soldering wires to 2-ch wireless wall switch
Post by: admin on December 12, 2016, 10:09:31 PM

Hi @lacoleman, there is no preferred route, it's just a matter of routing so you can still close the housing properly and not interfere with the operation.

Regards, Adrian

Title: Re: Routing wires when soldering wires to 2-ch wireless wall switch
Post by: lacoleman on December 13, 2016, 04:46:42 AM

OK, then I've got it.  Thanks.