Shade & Blind Motors: RollerTrol Community Forum
General Category => Tubular Motors: General Discussion => Topic started by: lacoleman on December 12, 2016, 05:36:41 PM
-
I am wiring a 2-ch DCC-2W-RF wall switch using the wiring bundle from a DCC-ZWAVE-12R motor controller, connecting the wires to the pushbutton switches on the CB. My question is whether there is a normal, preferred routing for the wires through the back of the wall switch unit. I can see three possible routes but would rather follow the lead of someone who is has done this or is otherwise familiar with the usual practice. Thanks.
-
Hi @lacoleman, there is no preferred route, it's just a matter of routing so you can still close the housing properly and not interfere with the operation.
Regards, Adrian
-
OK, then I've got it. Thanks.